How to install toilet bolts to tank how to#
Since you don’t have any plans to know how to replace a toilet tank lever, dump the detached tank and its accessories. Finally, place it on a towel that you put on the bathroom floor.
Gently raise the item to avoid any cracks or loose valves from entering the tank. Hold both ends of the bottom of the toilet tank. Step 5: Detach the Tank from the Toilet Bowl Repeat this action on the other bolts of the cistern. Since you have loose nuts, remove them from the inner part of the tank. With a screwdriver in your other hand, reach inside the tank and unscrew the bolt heads.Īs you turn the bolts, the nuts should become free. Next, take a pair of locking pliers and hold the nuts firmly. Go for the outer bolts at the bottom of the cistern. Step 4: Extract the Bolts on the Toilet Tank At this stage, place a container under the bowl to collect any spills from the loose hose. But if you can’t grip the item correctly, use a wrench or pair of pliers. You can perform this task with your hands. Then, loosen the end of the pipe that stays on the container. Look for a plastic or metal tube that connects the tank to the water valve.
Step 3: Disconnect the Supply Hose on the Toilet Tank If the tank refills, especially after releasing the toilet handle, you should tighten the water valve. Remember to hold down the lever until you have an empty cistern.ĭo you notice any water spills in the tank? Mop them with a rag or sponge to avoid potential drips on your bathroom floor. Push down the toilet handle to flush out the water in the tank. Set a towel on the floor and place the lid of the tank on it. Step 2: Drain the Water from the Toilet Tank After cutting off the water supply, you can work on the unit. Rotate the handle with anticlockwise movements to stop water from flowing into the cistern. In case it's not obvious, I'm just a home DIY'er I purchased the Eco Drakes probably 10 years ago after reading recommendations on this forum - one of the best decisions I've made in that time. Step 1: Disconnect the Toilet from the Water SupplyĬheck the wall for a metal valve that connects to the toilet tank. Taking a dremel tool to the wing nuts may be a future project!Īny thoughts or concerns with the silver bolts? Or tips for better addressing the tight clearance for the water inlet line? As a temporary workaround I connect the water line directly to the tank, positioning the wings so that they did not contact the bowl, and then did the final placement of the tank on the bowl.
The tank is operating great, and certainly looks good - but, upon installation I discovered that with the new tank the more squared off shape brings the water inlet pipe so close to the bowl that the plastic wing nuts for the water inlet line hit the bowl.
Is that standard with these new tanks? I have a query in to Toto, but have not received a reply yet. the brass bolts that were with the original tank. The parts with the new tank included two silver bolts vs. Needing the toilet to be operational, I installed the new tank and it fit well (in general) as expected. From a search of the Ferguson site, I see the ST776EA is listed as a replacement for the ST743E. Nothing was available locally, so I ordered online. Not wanting to take a chance on a failure in the middle of the night, I opted to order a replacement tank, a ST743E#01. One of our Eco Drake toilets developed a leak from the original tank and upon inspection I found a couple of what appeared to be small hairline cracks on the bottom of the inside of the tank.
0 kommentar(er)
